| Mass |
13.2 kg |
| Size |
560 mm |
| Surface of rotor |
Coated in black |
| Material of electronics housing |
Die-cast aluminium, coated in black |
| Material of blades |
Aluminium sheet insert, sprayed with PP plastic |
| Material of guard grille |
Steel, coated in black plastic (RAL9005) |
| Number of blades |
5 |
| Blade angle |
-5 |
| Direction of air flow |
"V" |
| Direction of rotation |
Counter-clockwise, seen on rotor |
| Type of protection |
IP 54 |
| Insulation class |
"B" |
| Humidity class |
F4-1 |
| Max. permissible ambient motor temp. (transp./ storage) |
+80 °C |
| Min. permissible ambient motor temp. (transp./storage) |
-40 °C |
| Mounting position |
Shaft horizontal or rotor on bottom; rotor on top on request |
| Condensate discharge holes |
Rotor-side |
| Cooling bore / aperture |
On rotor sides |
| Operation mode |
S1 |
| Motor bearing |
Ball bearing |
| Technical features |
- Output 10 VDC, max. 10 mA
- Alarm relay
- Motor current limit
- PFC, active
- Soft start
- Control input 0-10 V
- Control interface with SELV potential safely disconnected from the mains
- Over-temperature protected electronics / motor
- Line undervoltage / phase failure detection |
| EMC interference immunity |
Acc. to EN 61000-6-2 (industrial environment) |
| EMC harmonics |
Acc. to EN 61000-3-2/3 |
| EMC interference emission |
Acc. to EN 61000-6-4 (industrial environment) |
| Touch current acc. IEC 60990 (measuring network Fig. 4, TN system) |
<= 3,5 mA |
| Motor protection |
Thermal overload protector (TOP) wired internally |
| Cable exit |
Variable |
| Protection class |
I (if protective earth is connected by customer) |
| Product conforming to standard |
EN 61800-5-1 / CE |
| Approval |
GOST |
